Section 7: Installing & Removing The Door - Montigo P42DF Installation & Maintenance Manual

P42DF* Indoor Gas Fireplace
Section 7: Installing & Removing the Door
Removing the door:
The P42DF* doors are removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
Remove the Horizontal Access Panel:
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.
Step 1: Remove the Horizontal Access Panel:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it aside
during maintenance or cleaning.
Install in reverse order.
Figure 23. Removing and installing the Horizontal Access Panel
Locate the Door Buckles:
Step 2:
Page 22
Installation
Finger Holes
Installed Gas
Valve Cove r
Figure 21a. Locate the door buckles. (Both Sides Typical)
Step 3:
Release the Door Buckles
Hand-hold
Figure 23a. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 23b.
Step 5:
Ensure the tool is firmly in
the lower end of the slot,
(as shown), Then pull toward
you (Caution: hold the tool
securely).
Figure 23c.
Step 6:
Pull hard if necessary to
release the spring tension.
(Caution: The latch springs
back with force, hold the tool
securely).
Figure 23d.
Step 7:
Remove the tool from the
latch slot. Ensure the latches
are hanging freely, the hook
end is released from the
bottom of the door. (Repeat
all 4-steps for the remaining
latches).
Figure 23e.
Door Latch Slot
Door Latch Hook
1
2
3
4
XG0195 - 150204.2