Section 6: Screen Installation And Removal - Montigo P42DF Installation & Maintenance Manual

Section 6: Screen Installation and Removal

Removing / Attaching Screens:
To Remove Screens:
Grasp each top outer corner of the screen with your thumb and
finger and pull towards yourself. When the upper Screen Studs are
free, lift the screen at an angle from the lower slots from which the
Screen Bottom Tabs are held. Place the screen in a safe place.
To Install Screens:
Hold the screens at an angle away from the fireplace, and locate
the Screen Bottom Tabs at the lower corners of the screen. Place
the screen into the Screen Tab Receptacles in the lower section
of the fireplace.
Make sure the tabs and screens are lowered all the way down
into the Screen Tab Receptacles on the fireplace. Then, push
each Upper Screen Stud on the top corners of the screen into
the Upper Screen Stud Receptacles in the fireplace.
Figure 22a. Screen Door Numbers (Replacement Parts)
XG0195 -150204.2
Installation
Upper Screen
Stud Catch
Screen Tab
Receptacles
Figure 22b. Screen Installation and Removal
Replacement Screens:
For replacement part order numbers, please refer to section
"Replacement Parts:" on page 30.
Note: Do not operate fireplace without all screens in place.
P42DF* Indoor Gas Fireplace
Left Side Detail
Left Side Detail
Upper Screen
Re
Studs
Th
To R
Sim
out
wit
fin
you
Scr
an
fro
wh
Tab
scr
To I
Ho
ang
fire
Scr
low
scr
Tab
low
fire
tab
low
int
Rec
fire
Up
top
int
Stu
fire
Screen Bottom
Tabs
Page 21