Lorex LH050 ECO SERIES Instruction Manual page 55

15 Using the Main Menu
To set up email notification:
1. Click the Email tab in the Network menu.
2. From the Email drop-down menu, select from:
• Default: Uses the Lorex email server to send out notifications. This is the recom-
mended selection.
• Enable: Uses custom email server settings.
• Disable: Disables email notification.
If you want to use Lorex's email server (recommended):
1. In the Email drop-down menu, select Default.
2. In the Sender Email field, enter the email address of the sender. This can be any
email address of your choice.
3. Under Reciever Email, click Setup and enter the email addresses you want the DVR
to send notifications to.
4. In the Interval drop-down menu, enter the duration the DVR must wait before sending
out a new notification.
For example, if you select a 3 minute interval, the DVR will send out email notifications
every 3 minutes until the DVR stops detecting motion. The DVR will only send out noti-
fications when it detects motion.
5. Click Apply to save your settings.
If you select "Enable", and want to use your own email server:
1. Configure the following:
• SSL: Select ON/OFF to enable/disable Secure Socket Layer protocol.
• SMTP Port: Enter the port used by your SMTP server.
• SMTP Server: Enter your SMTP Server address.
• Sender Email: Enter the sender email address. This can be any address of your
choice.
• Sender Password: Enter your email server's password.
• Receiver Email: Enter the recipient's email address.
• Interval: Enter the interval the DVR waits before sending a new email notification.
#LX400066; r. 1.0/26388/26388; en-US
47