Initial Settings - Panasonic X-TG9385BX Operating Instructions Manual

TG9385BX(e).book Page 14 Monday, November 2, 2009 1:26 PM
Getting started

Initial settings

Symbol meaning:
Symbol Meaning
Perform with the handset.
Y
Perform with the base unit.
[
Example: Press {V} or {^} to select
{V}/{^}: "Off" the words in quotations.
Display language
3 display languages are available.
You can select "English", "
The default setting is "English".
Y Handset / [ Base unit
1
{MENU} i {#}{1}{1}{0}
2
{V}/{^}: Select the desired setting.
3
Press the middle soft key to save.
4
Proceed with the operation for your unit.
Handset: {OFF}
Base unit: {■} (EXIT)
Dialing mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is "Tone".
"Tone": For tone dial service.
"Pulse": For rotary/pulse dial service.
Program this setting using either one of the
handsets or the base unit.
Y Handset / [ Base unit
1
{MENU} i {#}{1}{2}{0}
2
{V}/{^}: Select the desired setting.
3
{SAVE}
4
Proceed with the operation for your unit.
Handset: {OFF}
Base unit: {■} (EXIT)
Date and time
Program this setting using either one of the
handsets or the base unit.
Y Handset / [ Base unit
1
{MENU} i {#}{1}{0}{1}
14
2
Enter the current date, month, and year by
selecting 2 digits for each.
Example: 15 July, 2010
{1}{5} {0}{7} {1}{0}
3
Enter the current hour and minute by selecting
2 digits for each.
Example: 15:30
{1}{5} {3}{0}
4
{SAVE}
5
Proceed with the operation for your unit.
Handset: {OFF}
Base unit: {■} (EXIT)
Note:
L When you select Arabic or Persian as the
", or " ".
display language, enter the current year, month,
and date.
L To correct a digit:
Handset: Press {^}, {V}, {<}, or {>} to move
the cursor to the digit, then make the correction.
Base unit: Press {^}, {V}, {7}, or {8} to
move the cursor to the digit, then make the
correction.
L The date and time may be incorrect after a
power failure. In this case, set the date and time
again.
Line selection mode
The line selection mode determines which line is
selected when:
– you press {C}/{s} on the handset (when
making/answering calls).
– you press {SP-PHONE} on the base unit (when
making/answering calls).
The following settings are available:
– "Auto" (default): When making a call, line 1 is
selected. If that line is unavailable, line 2 is
selected. When you call back using the caller list
(page 32) or while listening to a message (page
36, 37), the indicated line is used. When
answering a call, the ringing line is selected.
– "Line1": Line 1 is selected.
– "Line2": Line 2 is selected.
Y Handset / [ Base unit
1
{MENU} i {#}{2}{5}{0}
2
{V}/{^}: Select the desired setting.
3
{SAVE}
4
Proceed with the operation for your unit.