Radio Operations - Clarion CZ100E Owner's Manual & Installation Manual

Radio Operations

Select tuner as playing source
Press [SRC] button once or more to enter
radio mode.
Select one radio band
Press the [BAND] key on the panel to select
one radio band among FM1, FM2, FM3, MW
and LW.
Manual tuning
During manual tuning, the frequency will be
changed in steps.
Press the [ ]/[
tune in a higher / lower station.
Auto tuning
Press and hold the [
panel to seek a higher / lower station.
To stop searching, repeat the operation
above or press other keys having radio
functions.
Note:
When a station is received, searching stops
and the station is played.
If the unit receives a stereo broadcasting,
the indicator light of stereo 'ST' on the LCD
display will be lighted.
Auto store
Only stations with sufficient signal strength
will be detected and stored in the memory.
Press and hold the [PS/AS] (2 sec.) to start
automatic station search.
To stop auto store, press other keys having
radio functions.
Notes:
1. After auto store, the previous stored
stations will be overwritten.
2. The unit has 5 bands, such as FM1, FM2,
FM3, MW, LW. FM3 and MW, LW can
store by AS function. Each bands can
store 6 stations, CZ100E can store 30
stations in total.
Downloaded from Caradio-Manual.com Manuals
] key on the panel to
]/[ ] key on the
Manual store
When one expected radio station has been
detected, press and hold number key 1~6 to
store it in the memory.
Recall the stored stations
Press one numeric key among 1 to 6 on
the panel to select the corresponding stored
station.
Local seeking
When LOCAL seeking is on, only those radio
stations with strong radio signal could be
received.
To open or close LOCAL function, press and
hold the [ADJ] key on the front panel, then
press [ ] key repeatedly until LO or DX
displays on the screen, and rotate the knob
to select Local or Distant mode.
Note:
The number of radio stations that can be
received will decrease after the local seeking
mode is on.
Preset scan
Preset scan receives the stations stored
in preset memory in order. This function is
useful when searching for a desired station in
memory.
1. Press the [PS/AS] button.
2. When a desired station is tuned in, press
the [PS/AS] button again to continue
receiving that station.
Note:
• B e careful not to press and hold the
[PS/AS] button for 2 seconds or longer,
otherwise the auto store function is
engaged and the unit starts storing
stations.
9