Hot-Plug Drive Blanks - HP ProLiant DL180 Gen9 Service Manual

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
Power down the server (on page 26).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the non-hot-plug drive.
4.
Remove the drive from the carrier.
5.
To replace the component, reverse the removal procedure.

Hot-plug drive blanks

CAUTION:
all bays are populated with either a component or a blank.
To prevent improper cooling and thermal damage, do not operate the server unless
To prevent improper cooling and thermal damage, do not operate the server unless
Removal and replacement procedures 35