Hot-Plug Drive Blanks - HP ProLiant DL180 Gen9 Service Manual

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
Power down the server (on page 27).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If installed, remove the security bezel
4.
Remove the non-hot-plug drive.
5.
Remove the drive from the carrier.
6.
To replace the component, reverse the removal procedure.

Hot-plug drive blanks

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
If installed, remove the security bezel
1.
Remove the drive blank.
2.
To prevent improper cooling and thermal damage, do not operate the server unless
("Remove the security bezel
To prevent improper cooling and thermal damage, do not operate the server unless
("Remove the security bezel
(optional)" on page 27).
(optional)" on page 27).
Removal and replacement procedures 35