Remove The Server From The Rack; Remove The Pci Riser Cages - HP ProLiant DL180 Gen9 Service Manual

Open the cable management arm. The cable management arm can be right-mounted or left-mounted.
2.

Remove the server from the rack

WARNING:
equipment:
Observe local occupational health and safety requirements and guidelines for manual
•
material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. HP recommends that a minimum of two people are required
for all rack server installations. A third person may be required to help align the server if the
server is installed higher than chest level.
Use caution when installing the server in or removing the server from the rack; it is unstable
•
when not fastened to the rails.
To remove the server from an HP, Compaq-branded, Telco, or a third-party enclosure:
Power down the server (on page 26).
1.
Extend the server on the rack rails until the server rail-release latches engage.
2.
Disconnect all peripheral cables from the server.
3.
Disconnect each power cord from the server.
4.
Remove the server from the rack.
5.
For instructions on how to extend or remove the server from the rack, see the documentation that ships
with the rack rail system.
Place the server on a sturdy, level surface.
6.

Remove the PCI riser cages

CAUTION:
disconnect all power cords before removing or installing the PCI riser cage.
This server is very heavy. To reduce the risk of personal injury or damage to the
To prevent damage to the server or expansion boards, power down the server, and
Removal and replacement procedures 29