Adjustments To The Position Of The Output Image - Xerox Color 800i System Administration Manual

Profiles
misregistered. To reduce the possibility of size differences, it is recommended that
you use paper from the same lot when running duplex jobs.
• During the fusing process, the heat and pressure applied to the paper causes the
paper to stretch. If the images on sides 1 and 2 are the same size, the stretching of
the paper may cause the image on side 1 to be slightly larger than the image on side
2.
Creating an Alignment profile for these types of jobs allows you to reduce or eliminate
the images being larger on side1 than on side 2 prints.
Note
Once an Alignment profile is set and in use, your print server will not reflect that profile
in the print options for print jobs.

Adjustments to the position of the output image

The following adjustments can be made to the position of the output image:
• Registration:
- Lead Registration: Use this feature to adjust the lead edge of the image for side
1 and/or side 2 registration.
- Side Registration: Use this feature to adjust the side edge of the image for side
1 and/or side 2 registration.
• Perpendicularity: Use this when the image is straight on the page, but the corners
are slanted, not at right (90 degree) angles to each other. This feature adjusts the
image digitally on the drum so that it will align with the paper for both side 1 and
side 2.
• Skew: Use this when the entire image on the page is slanted and not straight. This
feature adjusts the paper so that the image for side 1 and/or side 2 are not skewed
but aligned with each other.
6-4 Xerox ® Color 800i/1000i Presses Xerox ® Color 800/1000 Presses
System Administration Guide