Removal Of The Fork - PEUGEOT SpeedFight 3 Workshop Manual

Removal of the fork

- Remove the rear shield panel. See:
Procedure 5 Page 22.
- Remove the handlebars from the fork tube.
(1 screws and 1 nuts) (1).
When re-installing, use a new nut.
Tightening torque: 40 Nm.
- Suspend or immobilize the machine
securely.
- Remove the front brake caliper from the fork
tube.
Tightening torque: 45 Nm.
- Remove the front wheel.
Tightening torque: 65 Nm.
When re-installing, use a new nut.
- Remove the front mudguard.
- Remove the brake control cable grommet
and the speed sensor located under the fork
triple clamp (2) (2 screw).
- Using tool P/N 757860 remove the steering
locknut.
- Remove:
• The lock washer.
• The nut.
• the rubber washer.
• The nut.
• The dust cover.
• The upper cone.
- Remove the fork.
- Remove the caged ball bearings.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
2
757860
STEERING/FORK
43