Manual Inputting Gps Location (Lat/Lon) - Standard Horizon MATRIX GX3000S Owner's Manual

11.10 MANUAL INPUTTING GPS LOCATION ( LAT/LON )
You may send the Latitude/Longitude of your vessel manually even if the
GX3000S is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the [ CALL ( MENU )] key until
" Radio Setup Radio Setup Radio Setup
Radio Setup Radio Setup
2. Turn the CHANNEL selector knob to select "
Setup Setup Setup " menu.
Setup Setup
3. Press the [ ENT ] key, then select "
the CHANNEL selector knob.
4. Press the [ ENT ] key. The transceiver will beep, and
the display will be as shown in the illustration on the
right.
5. Enter the your local time by the 24-hour system on
the UTC time. Use the [ ENT ] and [ H/L ( NAV )] key to
navigate to each column of the time, then use the
CHANNEL selector knob to select the desired num-
bers in each colum. Repeat for each column, to com-
plete the time.
6. Enter the Latitude/Longitude of your vessel location
with the same procedure as description above.
7. To store the data entered, press the [ ENT ] key. To
exit this menu and return to radio mode press the
[ 16/9 ] key.
Page 58
" menu appears.
DSC DSC
DSC DSC DSC
POS Input POS Input POS Input " with
POS Input POS Input
GX3000S