Manual Inputting Of The Gps Location (Lat/Lon) - Standard Horizon Eclipse DSC+ GX1100E Owner's Manual

9.11 MANUAL INPUTTING OF THE GPS LOCATION ( LAT/LON )
You may send the Latitude/Longitude of your vessel manually even if the
GX1100E is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the [ CALL ( MENU )]
key until "SETUP MENU SETUP MENU" appears.
SETUP MENU SETUP MENU
SETUP MENU
2. Press the [ ( UP )] / [ ( DOWN )] keys to se-
lect "POS INPUT POS INPUT" menu.
POS INPUT POS INPUT
POS INPUT
3. Press the [ ENT ] key. The transceiver will beep,
and the display will be as shown in the illustration
on the right.
4. Enter your local time by the 24-hour system
on the UTC time. Use the [ ENT ] and the
microphone's [ H/L ] key to navigate to each
column of the time, then use the [ ( UP )] /
[ ( DOWN )] keys to select the desired num-
bers in each colum. Repeat for each col-
umn, to complete the time.
5. Enter the Latitude/Longitude of your vessel
location with the same procedure as de-
scription above.
6. To store the data entered, press the [ ENT ] key. To
exit this menu and return to radio mode press the
[ 16/9 ] key.
Page 52 GX1100E