Griddle; The Wok Cradle; Control Panel And Oven Doors - Rangemaster Professional+ FXP 90 Dual Fuel User's Manual & Installation Instructions

Range cooker
Hide thumbs Also See for Professional+ FXP 90 Dual Fuel:
Table of Contents

Advertisement

Fig. 5.2
ArtNo.311-0014 Wok burner details
A
B
C
D
E
A – Inner burner cap, B – Outer burner cap, C – Inner burner head,
D – Outer burner head, E – Wok burner base
Fig. 5.3
Fig. 5.4
B
A
ArtNo.311-0016 Fitting the burner inner head
A – Electrode notch, B – Ignition electrode
Fig. 5.5
ArtNo.272-0015 - 90DF - Pro+ - Removing the outer door panel
The Wok Burner
When reassembling the wok burner (Fig. 5.2) turn over the
large base ring and find the 'D' shaped area (Fig. 5.3). Turn
the head until the 'D' matches the one on the burner base.
Flip the burner over once again and place it on the burner
base.
To fit the small inner burner, find the larger electrode notch
in the burner rim. Line this up with the ignition electrode and
place the inner burner on the large base ring (Fig. 5.4).
Now fit the two burner caps, making sure that they are seated
properly.
Check the burner ports are not blocked. If a blockage occurs,
remove stubborn particles using a piece of fuse wire.

Griddle

Always clean the griddle after use. Allow it to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.

The Wok Cradle

Recommended cleaning materials are hot soapy water, a
moistened soap pad, cream cleaner or nylon scourer.

Control Panel and Oven Doors

The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
Removing the Oven Door Outer Panel
The outer door panel can be removed so that the inside of
the glass can be cleaned. Undo the 4 screws (2 each side) in
the door (Fig. 5.5).
Open the door slightly and, using the handle, carefully lift the
door outer upwards.
Refit in reverse.
16

Advertisement

Table of Contents
loading

Table of Contents