Section 10 Concept Of Slot Number - NEC SL1100 Programming Manual

SL1100
S 10 CONCEPT OF SLOT NUMBER
ECTION
Each unit installed to the system has a slot number assigned. Some of slot number are fixed to a unit
that be installed. Other slots are not fixed to unit but fixed to location where it is installed. Below chart
shows the slot and its number :
Main KSU
Slot 10 4th Unit*
Slot 2 2nd Unit
Slot 1 Base Unit
* Note: Lot D or higher Main KSU or FPGA Version 0100 and V3.5 or higher System Software required.
FPGA version can be found in PC Pro/Web Pro and Lot # is on side of Chassis.
- To verify if your Chassis is D or higher check the lot # (e.g. 118DCA-G). The 4th Character
needs to be D or higher.
- To verify the FPGA version connect with PC Pro/Web Pro and check version information in the
blade configuration screen.
However the maximum trunk port will be limited to 84 ports even though the expansion Trunk card
is fully mounted into the four KSUs.
Please see the hardware manual for further information.
1-8
Slot 0 Base Unit
C
Slot 3 3rd Unit
P
U
Expansion KSU 1-3
Slot 11/12/- 4th Unit
Slot 6/9/15 3rd Unit
Slot 5/8/14 2nd Unit
Slot 4/7/13 Base Unit
ISSUE 4.0
E
X
I
F
E
Introduction