System Setup Menu; Engine Displayed; Bus Devices; Sonar Alarms - Lowrance LMF-400 Installation And Operation Instructions Manual

1. From the Fuel Setup menu, select and press Enter,
R T F
ST RIP UEL
which will launch the following message: Press Enter to Reset Trip
Fuel.
2. Press , which will take you back to the Fuel Setup menu. Press
ENTER
repeatedly to return to the main display.
EXIT

System Setup Menu

To get to the System Setup menu, press , then scroll down to
MENU
System Setup and press . The System Setup menu contains
ENTER :
Engine Displayed, Bus Devices, Sonar Alarms, Eng/Tank
Configuration, Reset Values, System Information and Change Units.

Engine Displayed

The Engine Displayed command allows you to monitor up to three
engines on your vessel.
Basic menu with System Setup highlighted (left). System Setup menu
(right) with Engine Displayed selected.
1. After accessing the System Setup menu, highlight
E D
NGINE ISPLAYED
and press . A menu will appear with the following options: Port,
ENTER
Center and Starboard. This is important when viewing information like
Fuel Management, RPM and Engine Voltage.
2. Select the engine you would like to monitor and press .
ENTER

Bus Devices

1. To run a system check for devices connected to the NMEA 2000
network, choose from the System Setup menu and press
B D
US EVICES
After a Searching for Bus Devices message comes up, a list of
ENTER.
all devices attached to the LowranceNET — the Bus Devices list — will
appear.

Sonar Alarms

1. If you would like to set Deep or Shallow Sonar Alarms, select
S
ONAR
from the System Setup menu and press . An alarm menu
A ENTER
LARMS
will pop up with two choices: Shallow or Deep.
38