Table of Contents
Advertisement
To Customize the Quad Analog page:
1. Scroll through the pages set for display by pushing the
key.
2. Once the Quad Analog page is displayed, press
and press
C
USTOMIZE
3. A menu prompt will appear giving you the option to customize the
gauge on the Top Left, Top Right, Bottom Left or Bottom Right.
4. Use the
UP
customize and press
5. Scroll through the device list and highlight the desired item, then
press
. This will take you back to the gauge menu prompt. If you
ENTER
want to customize any of the other gauges, repeat the steps above,
otherwise press
displayed on the main screen.
NOTE:
If a page is customized to show information from a device that is
working improperly or is not connected to the NMEA 2000 network,
the data boxes on the gauge will flash. This indicates the device is
not sending data to the Bus. This could occur for a variety of
reasons, depending on the device type. If it is a GPS sensor, the
GPS unit probably has not locked on to a satellite yet and may take
a few moments to acquire a position. All other EP sensors need to
be configured, which may be done via Bus Devices in the System
Setup menu.
Quad Analog page (left) with Single Digital page (right).
Single Digital
The single digital page displays a single digital gauge that can display:
Alt Voltage, Battery Voltage, Engine Temperature, Atmospheric
Pressure, Temperature, Depth, Engine Load, Total Engine Hours, Fuel
Flow, Fuel Economy, Fuel Remaining, Fuel Range, Paddle Wheel
Speed, Pitot Speed, GPS Speed and Tachometer.
.
ENTER
and
keys to highlight the gauge you want to
DOWN
.
ENTER
,
. The information you selected will be
EXIT
EXIT
33
or
ENTER
EXIT
, select
MENU
Hide quick links:
Advertisement
Table of Contents
