Gps Position; Fuel Manager; Fuel Setup; Adjust Calibration - Lowrance LMF-400 Installation And Operation Instructions Manual

GPS Position

Displays user position in Latitude/Longitude.

Fuel Manager

The Fuel Manager page has three digital readouts capable of
displaying: Fuel Flow, Fuel Economy, Fuel Remaining, Fuel Range,
Trip Fuel Used, Seasonal Fuel, Paddle Wheel Speed, Pitot Speed and
GPS Speed. While on the Fuel Manager page, press
Fuel manager menu, which contains the following options: Customize,
Fuel Setup, Pages, Screen, Audio Setup and System Setup.
NOTE
If you have multiple engines, you must go into System Setup and
select Engine Displayed. Here you can select the engine you want to
set up. The Fuel Management page shows the engine you selected
at the bottom of the page.
To Customize the Fuel Manager Page:
1. Scroll through pages set for display using the
2. Once the Fuel Manager page is displayed, press
and press
C
USTOMIZE
3. The menu prompt will appear with the follow options: Top Data,
Center Data and Bottom Data. Use the
the data box you want to customize and press
4. Scroll through the list and highlight the desired item, then press
. This will take you back to the menu prompt. If you want to
ENTER
customize other data, repeat the steps above, otherwise press
. The information you selected will be displayed on the screen.
EXIT

Fuel Setup

1. To access the Fuel Setup menu, press
Manager page, which will bring up the Fuel Manager page menu.
2. Select
F
UEL
The Fuel Setup menu contains the following categories: Adjust
Calibration, Fuel Remaining Source, Reset Seasonal, Refill Tank,
Partial Fill, Eco Speed Source and Reset Trip Fuel.

Adjust Calibration

1. From the Fuel Setup menu, select
2. Use the
UP
adjustment, then press

Fuel Remaining Source

The Fuel Remaining Source menu prompts you to choose what sensor
will be used to monitor your fuel level. There are two options: Engine
Fuel Flow and Fluid Level Sensor.
.
ENTER
, then press
S
ETUP
and
DOWN
ENTER.
and
UP
MENU
.
ENTER
A C
DJUST
keys to input the desired calibration
36
MENU
and
ENTER
MENU
keys to highlight
DOWN
.
ENTER
while viewing the Fuel
and press
ENTER
AL
to access the
keys.
EXIT
, select
,
EXIT
.