System Setup; Bus Devices; To Reset Values - Lowrance LMF-400 Installation And Operation Instructions Manual

3. Select or
O
N
main display.
4. If you choose to keep the current setting, press
Audio Setup menu
Adjusting Alarm Sounds:
1. To turn on or turn off Alarm Sounds, select
Audio Setup menu and press
2. Select or
O
N
main display.
3. If you choose to keep the current setting, press
menu.
A S
UDIO ETUP
4. Press repeatedly to return to the main display.
EXIT

System Setup

On each page, the System Setup menu contains, Engine Displayed,
Change Units, Bus Devices, Sonar Alarms, Eng/Tank Configuration,
Reset Values and System Information.
To access the System Setup menu, press
keys to highlight
DOWN
the System Setup menu in more detail in the Advanced Operation
section.

Bus Devices

One of the more significant commands in the System Setup menu is the
Bus Devices command. It allows you to run a system check for all
devices connected to the LowranceNet.
1. To run a system check for devices connected to the NMEA 2000
LowranceNet, press
and press
B D
US EVICES
message comes up, a list of all devices attached to the LowranceNET —
the Bus Devices list — will appear.
NOTE:
If you modify settings and are not satisfied with the results, you
can reset the gauge to its factory default settings via the Reset
Values command.

To Reset Values:

1. Press
MENU
2. Scroll down to
will appear: Press Enter to reset all values.
3. Press
ENTER
and press
O
FF
and press
O
FF
S
YSTEM
, select
MENU
ENTER.
, highlight
S
YSTEM
R V
ESET ALUES
to reset the values.
, which will take you back to the
ENTER
.
ENTER
, which will take you back to the
ENTER
, then press
S
ETUP
S S
YSTEM ETUP
After a Searching for Bus Devices
and press
S
ETUP
and press
ENTER
17
to return to the
EXIT
A S
LARM OUNDS
to return to the
EXIT
and use the
MENU
. We'll discuss
ENTER
and press
ENTER
.
ENTER
. The following message
from the
and
UP
. Choose