Fuel Flow (Port, Center And Stbd) - Lowrance LMF-400 Installation And Operation Instructions Manual

In the following example, we want to swap the configuration of Temp 2
and Temp 1. We will first unconfigure Temp 2, then reconfigure Temp 1
as Temp 2. We'll finish by configuring UnCfg Temp (formerly Temp 2)
as Temp 1.
1. Highlight
T
launch the temp sensor configuration menu.
2. Choose
U
NCONFIGURE
up: Hit Menu to UnCfg Temp Sns.
3. Press
ENTER
4. Select
T
EMP
and press
R
ECONFIGURE
Selection menu.
5. Select
T
EMP
Devices list.
6. Now highlight
which will call up the Selecting Temp menu. Choose one of the Temp
options (Temp 1, Temp 3, etc.) and press
the Bus Devices list.
NOTE:
To run a system check for devices connected to the NMEA 2000
network, select
. A Searching Bus Devices message comes up, followed by a
ENTER
list of all devices attached to the LowranceNET — the Bus Devices
list. To select an item from the bus devices list, use the
keys to scroll through the list. Highlight the desired category
DOWN
and press

Fuel Flow (Port, Center and Stbd)

Port Fuel Flow (Port Fflow), Center Fuel Flow (Cen Fflow) and
Starboard Fuel Flow (Stbd Fflow) all share the same internal
configuration menu, which includes: Change Engine (for two or more
engines only), Fuel Warning, Unset Engine and Reset Values. After
selecting a Fuel Flow (Port, Center or Stbd) from the Bus Device list
and pressing
ENTER
To Unconfigure Fuel Flow:
See Unset Engine below.
To Configure Fuel Flow:
1. From the Bus Devices list, highlight
That will launch the following message: Hit Menu to Cfg Flow Sns.
2. Press
ENTER
on the Bus Devices list and press
2
EMP
and press
, and you will be taken back to the Bus Devices list.
from the Bus devices menu and press
1
ENTER
and press
2 ENTER
U C T
N FG EMP
B D
US EVICES
.
ENTER
, the following options will appear in the menu.
to proceed with configuration.
. The following message will pop
ENTER
. That will direct you to the Temp
, which will take you back to the Bus
from the Bus Devices list and press
ENTER
from the System Setup menu and press
U
N
21
ENTER
. You will be returned to
and press
C F F
FG LOW
, which will
. Choose
ENTER
ENTER
and
UP
ENTER
,
.