Temperature Sensors; To Unconfigure A Temp Sensor; To Configure A Temp Sensor; To Reconfigure A Temp Sensor - Lowrance LMF-400 Installation And Operation Instructions Manual

NOTE:
If you configure the desired sensors and are not satisfied with the
results, you may clear the configuration settings for each sensor
individually, by resetting values from the sensor's configuration
menu. Remember, ONLY the sensor you select from the Bus
Devices list will be set back to its defaults. To reset the LMF-400 to
its defaults, you must select
Menu. We'll take a closer look at the
this section.
To get to the configuration menu:
1. Press
MENU
2. Highlight
B
detected in the network will be listed. Use the
scroll through the list.
3. To configure an item in the list, highlight the item and press

Temperature Sensors

When temperature sensors are selected from the Bus Devices menu,
the temp sensor configuration menu comes up with two choices:
or
U
NCONFIGURE

To Unconfigure a temp sensor:

1. After selecting a temp sensor from the Bus Devices list and pressing
, choose
ENTER
. The following message will appear: Hit Menu to UnCfg Temp
ENTER
Sns.
2. Press
ENTER
Bus Devices list.

To Configure a temp sensor:

1. If you highlight
asking if you want to configure the sensor.
2. Press
ENTER
3. Highlight one of the Temp options (Temp1, Temp 2, Temp 3, etc.) on
the Selecting Temp menu and press
been configured as the Temp you selected. You automatically will be
redirected to the Bus Devices list.

To Reconfigure a temp sensor:

If you want to reconfigure a sensor, but all the sensors linked to the
LowranceNET are already configured, you must first unconfigure a
sensor, so its name will be available. Otherwise a Name Already
Selected message will appear.
, select
S
YSTEM
and press
D
US EVICES
.
R
ECONFIGURE
U
NCONFIGURE
to unconfigure the sensor and be directed back to the
U C T
N FG EMP
to be taken to the Selecting Temp menu.
R V
ESET ALUES
R
and press
S
ETUP
ENTER.
from the configuration menu and press
and press
ENTER
ENTER
20
from the System Setup
command later in
V
ESET ALUES
.
ENTER
After a few moments, items
and
UP
, a window will pop up
. The UnCfg temp now has
keys to
DOWN
.
ENTER