Power Diagram A - Lowrance LMS-522c iGPS Installation And Operation Instructions Manual

The display power cable has three wires, white, red and black. Red is the
positive (+) lead, black is negative (–) or ground. The white wire is un-
used by your unit and should be capped. Make sure to attach the in-line
fuse holder to the red lead as close to the power source as possible.
For example, if you have to extend the power cable to the power bus or
battery, attach one end of the fuse holder directly to the power bus or
battery. This will protect both the unit and the power cable in the event
of a short.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.
To unit
Display Unit
Power Cable
Data Cable
Use this method if you are powering the display unit and a GPS mod-
ule or the display unit and a NMEA 2000 network. (Fuses may be dif-
The network and any NMEA 2000 devices, including the GPS
module, will not operate unless the NMEA 2000 Power Cable is
connected to power. The NMEA 2000 power cable must be connected
to power even if your only NMEA 2000 device is the GPS module and it
is connected to the display unit's Network socket. (However, never
connect multiple power sources to a NMEA 2000 network. If you
have a network that is already powered, see diagram B on page 33.)

Power Diagram A

NMEA 2000
Power Cable
3-amp fuse
Recommended
display unit
power-off switch
ferent from those shown.).
Mandatory
network
power-off
switch
Shield
Black
White
(unused)
32
3-amp fuse
Black
Red
12 volt DC
power source