1
1-10 Connecting to the Network
!
10/100BaseT Ethernet (RJ-45)
Dongle
Copier interface connector
Connecting network cable to the Océ 760C
In this section, the back panel of the Océ 760C is illustrated, followed by information
for connecting to the Ethernet board. For information about connecting to a Token
Ring network, see
Appendix
Shut down the Océ 760C before attaching it to any network device. If the Océ 760C
has just finished processing, wait five seconds after the system reaches the Idle state
before using the power switch to turn it off. For the proper shutdown procedure, see
page
7-12.
Back view of the Océ 760C
A.