Mitel 6867i User Manual page 135

Contact your telephone equipment retailer or distributor to purchase a compatible headset.
Notes:
1. The RJ22/R45 headset port is for headset use only. Plugging any other devices into
this port may cause damage to the phone and will void your warranty.
2. Customers should read and observe all safety recommendations contained in
headset operating guides when using any headset.
3. Contact your System Administrator for questions regarding supported headsets.
4. If both an analog (non-DHSG) headset and a USB headset are connected to the
phone, the USB headset will take precedence over the analog headset (i.e. the USB
headset will be functional while the analog headset will not be functional).
5. If both a DHSG headset and a USB headset are connected to the phone and DHSG
is enabled, the DHSG headset will take precedence over the USB headset.
VOLUME CONTROLS FOR THE HEADSET MICROPHONE
On the 6867i, there are three options for the headset microphone volume: Low, Medium, and
High. For information about configuring the headset microphone volume, see
.
page 62
MAKING AND RECEIVING CALLS USING A HEADSET
IP PHONE UI
1. Ensure that you have selected a headset audio mode (see
Using the IP Phone UI"
2. Turn the phone over and, depending on the type of headset, locate the headset jack marked
f or the USB port.
a. If you have a USB headset, insert the USB plug into the USB port.
b. If you have a headset with an RJ9/RJ22 4-pin connector, insert the headset cord into
the jack until it clicks into place.
c. If you have a DHSG/EHS headset with an RJ45 6-pin or 8-pin connector, remove the
plastic headset jack adapter and then insert the cord into the jack until it clicks into
place.
Note: See the Mitel 6867i SIP IP Phone Installation Guide for more information.
3. Press the key to obtain a dial tone or to answer an incoming call. Depending on
the audio mode selected from the Options List, a dial tone or an incoming call is received
on either the headset or the handsfree speakerphone.
4. Press the key to end the call.
on page 61.
Making Calls
"Headset"
"Configuring the Audio Mode
on
133