Mitel 6867i User Manual page 129

Settings. For more information about setting this parameter, see
page 203.
Expansion Module Keys
7. Select from Key 1 through Key 16 (M680i) or Key 84 (M685i).
8. In the Type field, select Paging.
9. In the Value field, enter a multicast IP address and a port number for the Paging key. When
you press this key, the phone initiates an outgoing multicast RTP session to the specified
address using the specified port. (For example, 239.0.1.15:10000).
Notes:
1. When you select Paging for the Type field, the Line field is disabled.
2. The Value field allows for one multicast address entry only.
10. To receive RTP steams for group paging, you must also configure the Paging Listen
Addresses parameter at the path, Basic Settings > Preferences > Group Paging RTP
Settings. For more information about setting this parameter, see
page 203.
11. Click Save Settings to save your changes
USING THE PAGING KEY
The following procedure describes the use of the Paging key on the IP phone. The procedure
assumes you have already configured the Paging key using the Mitel Web UI.
Notes:
1. The recipient of a paging call can set a global DND to ignore any incoming pages.
2. For incoming paging, the phone uses the Intercom configuration settings. The
incoming page is dependant on the Allow Barge In parameter setting and the
idling/on call state.
IP PHONE UI
1. On the IP phone, press the softkey or expansion module key you configured for Paging.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen
displays.
2. Press the Drop key to end the multicast RTP session and return to the Home screen.
Note: If you enable global DND on the phone, the incoming multicast RTP session is
dropped.
Configuring Softkeys
"Group RTP Paging" on
"Group RTP Paging" on
127