Table of Contents
Advertisement
4f. Connect the cable wires to the terminals on the blower as shown and to
the control box for the speed regulator.
Blower connection cable
After the cables have been connected,
check and ensure proper functionality before
finishing the installation. The cables must be
fixed using the holding flaps. The flaps can
either by pressed in from the outside or
levered out from the inside.
Once the cable has been pushed under the
flaps, the flaps must then be pushed down
lightly onto the cable.
PLEASE NOTE: Do not press on the
flaps too hard because otherwise the
cable could become damaged!
4g. Pull the rubber knob off
the front of the control shaft
and twist off the nut and ring
washer. The control shaft is
inserted through two holes in
the frame when installing the
frame. It may be necessary to
order a new cassette frame if the existing one does not have any correspond-
ing holes.
framework PAGE - 30 -
Mains supply
Hide quick links:
Advertisement
Table of Contents
