Closing A Secure Shell Session; Log Into The Switch With Secure Shell Ftp - Alcatel-Lucent OmniSwitch 6450 Management Manual

Logging Into the Switch

Closing a Secure Shell Session

To terminate the Secure Shell session, issue the
-> exit
Connection to 11.133.30.135 closed.
Using the example shown above, this display indicates the Secure Shell session between the two switches
is closed. At this point, the user is logged into the local OmniSwitch at IP address 11.233.10.145.
Note. Establishing and closing the Secure Shellv6 connection is similar to that of the Secure Shell connec-
tion.

Log Into the Switch with Secure Shell FTP

To open a Secure Shell FTP session from a local OmniSwitch to a remote device, issue the
and identify the IP address or hostname for the device you are connecting to.
You can use the sftp6
address or hostname, over an IPv6 environment.
The following example describes how a Secure Shell interface is established from the local OmniSwitch
to IP address
10.222.30.125
1 Log on to the OmniSwitch and issue the
identify the IP address or hostname for the device to which you are connecting. The following command
establishes a Secure Shell FTP interface from the local OmniSwitch to IP address 10.222.30.125.
-> sftp 10.222.30.125
login as:
Note. If SFTP is not enabled, use the
2 You must have a login and password that is recognized by the IP address you specify. When you enter
your login, the device you are logging in to, requests your password as shown here.
-> sftp 10.222.30.125
login as: rrlogin2
rrlogin2's password for keyboard-interactive method:
Note. You can use the
start an SFTPv6 session. It is mandatory to specify the name of the particular IPv6 interface, if the
SFTPv6 server has been specified using its link-local address. After logging in, you see the sftp> prompt.
You may enter a question mark (?) to view available Secure Shell FTP commands and their definitions as
shown here.
OmniSwitch 6250/6450 Switch Management Guide
command to start an Secure Shell FTPv6 session followed by the relevant IPv6
:
sftp
scp-sftp command to enable it.
sftp6 command followed by the IPv6 address or hostname of the SFTPv6 server to
exit command. The following is displayed:
CLI command. The command syntax requires you to
June 2013
Using Secure Shell
sftp command
page 2-19