Using Secure Shell Ftp - Alcatel-Lucent OmniSwitch 6450 Management Manual

Managing System Files
delete
dir
get
hash
help
ls
put
pwd
quit
remotehelp
user
lpwd
mput
mget
prompt
!ls
lcd
user
If you lose communications while running FTP, you may receive a message similar to the following:
Waiting for reply (Hit ^C to abort)...........
In this case you can press Crtl-C to abort the session or wait until the communication failure is resolved
and the FTP transfer can continue.
Note. You must use the binary mode (bin) to transfer files via FTP.

Using Secure Shell FTP

1 Log on to the OmniSwitch and issue the
identify the IP address for the device you are connecting to. The following command establishes a Secure
Shell FTP interface from the local OmniSwitch to IP address 10.222.30.125.
-> sftp 10.222.30.125
login as:
Note. If SFTP is not enabled on the switch, use the
You can use the sftp6
an SFTPv6 session over an IPv6 environment. For example:
OmniSwitch 6250/6450 Switch Management Guide
Delete a file on the remote machine.
Obtain a long listing on the remote machine.
Retrieve a file from the remote machine.
Print the hash symbol (#) for every block of data transferred.
(This command toggles hash enabling and disabling.)
Displays a list of FTP commands and their definitions.
Display summary listing of the current directory on the remote
host.
Send a file to the remote machine.
Display the current working directory on the remote host.
Close session gracefully.
List the commands that the remote FTP server supports.
Send new user information.
Display the current working directory on the local host.
Allows for the transfer of multiple files out of the local machine.
Allows for the transfer of multiple files into the local machine.
Toggles the query for use with the mput and mget commands.
Lists the contents (files and directories) of the local directory.
Change to a new local directory
Sends new user information.
sftp
command followed by the IPv6 address or hostname of the SFTPv6 server to start
CLI command. The command syntax requires you to
scp-sftp command to enable it.
June 2013
Loading Software onto the Switch
page 1-23