Managing CMM Directory Content
Displaying CMM Conditions
To show various
CMM
use the following CLI show commands:
show running-directory
show reload
show microcode
For more information on the resulting displays from these commands, see the OmniSwitch 6250/6450 CLI
Reference Guide. An example of the output for the show microcode command is given in
Files" on page
5-24.
OmniSwitch 6250/6450 Switch Management Guide
conditions, such as where the switch is running from and which files are installed,
Shows the directory from where the switch was booted.
Shows the status of any time delayed reboot(s) that are pending on the
switch.
Displays microcode versions installed on the switch.
June 2013
Displaying CMM Conditions
"Show Switch
page 5-35