SiBE121123_A
3.2.2 BRC1D528
If operation stops due to malfunction, the operation lamp on the remote controller blinks, and
error code is displayed. (Even if stop operation is carried out, malfunction contents are
displayed when inspection mode is entered.) The error code enables you to tell what kind of
malfunction caused operation to stop.
Refer to page 155, 156 for error code and malfunction contents.
Note:
1. When you press the [INSPECTION/TEST OPERATION] button, the inspection display
2. While in the inspection mode, press the [ON/OFF] button for 5 seconds or more to clear the
Service Diagnosis
Display of indoor unit
for which a malfunction
has been detected
Inspection display
[INSPECTION/TEST
OPERATION] button
blinks.
failure history indication. In this case, the error code blinks twice and then changes to 00 (=
Normal), the UNIT No. changes to 0 , and the operation mode automatically switches from
the inspection mode to the normal mode (displaying the set temperature).
Service Check Function
Operation lamp
[ON/OFF] button
Error code
(R14423)
150