Brc7E530W - Daikin 2MXS40H2V1B Service Manual

SA Indoor Unit
2.3

BRC7E530W

1
3
H M L
C
6
4
hr.
hr.
2
5
TEST
7
DISPLAY "
1
This lights up when a signal is being
transmitted.
DISPLAY "
(OPERATION MODE)
This display shows the current
2
OPERATION MODE. For straight cooling
type, "
not installed.
DISPLAY "
3
This display shows the set temperature.
DISPLAY "
(PROGRAMMED TIME)
4
This display shows PROGRAMMED TIME
of the system start or stop.
5
DISPLAY "
DISPLAY "
6
The display shows the set fan speed.
DISPLAY "
TEST OPERATION)
7
When the INSPECTION/TEST
OPERATION BUTTON is pressed, the
display shows the system mode is in.
ON/OFF BUTTON
8
Press the button and the system will start.
Press the button again and the system will stop.
FAN SPEED CONTROL BUTTON
9
Press this button to select the fan speed,
HIGH or LOW, of your choice.
TEMPERATURE SETTING BUTTON
Use this button for SETTING
10
TEMPERATURE (Operates with the front
cover of the remote controller closed.)
133
ON OFF
8
DOWN 10
UP
FAN
9
" (SIGNAL TRANSMISSION)
" " " " " " " "
" (Auto) and " " (Heating) are
H • L • M
" (SET TEMPERATURE)
˚C
"
hr. hr.
" (AIR FLOW FLAP)
" " " (FAN SPEED)
TEST" (INSPECTION/
ON OFF
TEMP
TIME
11
H M L
C
UP
DOWN
FAN
13
RESERVE CANCEL
hr.
12
TIMER
hr.
MODE
15
SWING
14
16
TEST
TEST
17
(R17880)
PROGRAMMING TIMER BUTTON
Use this button for programming "START
11
and/or STOP" time. (Operates with the front
cover of the remote controller opened.)
"
12
TIMER MODE START/STOP BUTTON
13
TIMER RESERVE/CANCEL BUTTON
14
AIR FLOW DIRECTION ADJUST BUTTON
OPERATION MODE SELECTOR BUTTON
15
Press this button to select OPERATION MODE.
16
FILTER SIGN RESET BUTTON
INSPECTION/TEST OPERATION BUTTON
17
This button is used only by qualified service
persons for maintenance purposes.
EMERGENCY OPERATION SWITCH
18 This switch is readily used if the remote
controller does not work.
RECEIVER
19
This receives the signals from the remote controller.
OPERATING INDICATOR LAMP (Red)
20
This lamp stays lit while the air conditioner
runs. It flashes when the unit is in trouble.
TIMER INDICATOR LAMP (Green)
21
This lamp stays lit while the timer is set.
AIR FILTER CLEANING TIME
INDICATOR LAMP (Red)
22
Lights up when it is time to clean the air filter.
DEFROST LAMP (Orange)
Lights up when the defrosting operation
23
has started. (For straight cooling type this
lamp does not turn on.)
SiBE121123_A
21 20 22 23
19
18
(R17873)
Remote Controller