ZyXEL Communications Prestige 792H User Manual page 180

Prestige 792H User's Guide
LABEL
Local Address Type Use the drop-down menu to choose Single, Range, or Subnet. Select Single for a
IP Address Start When the Local Address Type field is configured to Single, enter a (static) IP
End / Subnet Mask When the Local Address Type field is configured to Single, enter the IP address in
Remote
Remote Address
Type
IP Address Start When the Remote Address Type field is configured to Single, enter a (static) IP
14-10
Table 14-7 VPN IKE
single IP address. Select Range for a specific range of IP addresses. Select Subnet
to specify IP addresses on a network by their subnet mask.
address on the LAN behind your Prestige. When the Local Address Type field is
configured to Range , enter the beginning (static) IP address, in a range of
computers on your LAN behind your Prestige. When the Local Address Type field is
configured to Subnet, this is a (static) IP address on the LAN behind your Prestige.
the IP Address Start field again here. When the Local Address Type field is
configured to Range, enter the end (static) IP address, in a range of computers on
the LAN behind your Prestige. When the Local Address Type field is configured to
Subnet, this is a subnet mask on the LAN behind your Prestige.
Remote IP addresses must be static and correspond to the remote IPSec router's
configured local IP addresses. The remote fields do not apply when the Secure
Gateway Address field is configured to 0.0.0.0. In this case only the remote IPSec
router can initiate the VPN.
Two active SAs can have the same configured local or remote IP address, but not
both. You can configure multiple SAs between the same local and remote IP
addresses, as long as only one is active at any time.
Use the drop-down menu to choose Single, Range, or Subnet. Select Single with a
single IP address. Select Range for a specific range of IP addresses. Select Subnet
to specify IP addresses on a network by their subnet mask.
address on the network behind the remote IPSec router. When the Remote Address
Type field is configured to Range, enter the beginning (static) IP address, in a range
of computers on the network behind the remote IPSec router. When the Remote
Address Type field is configured to Subnet, enter a (static) IP address on the
network behind the remote IPSec router.
DESCRIPTION
VPN Screens