Wire Harness, Hose Routing And Sensor Installation; Wire Harness Routing - Suzuki 2006 GSF1200AK6 Supplementary Service Manual

76 GSF1200AK6/SAK6 ('06-MODEL)

WIRE HARNESS, HOSE ROUTING AND SENSOR INSTALLATION

WIRE HARNESS ROUTING

Handle switch
harness
Starter cable
*2
Starter
cable
Throttle
cables
*3
*4
*1 Cut the tip of wire clamp after clamping.
*2 Set the plug cap forward.
*3 Don't pull this lead wire.
*4 Tip of wire clamp backward.
*1
PAIR hose
Clamp
Starter
cable
Thermo switch
(E-02, 19)
Clamp
Wiring
harness
ABS pipe
Thermo switch
(E-02, 19)
Clamp
Clamp
Handlebar switch (LH and RH)
Ignition switch
Front ABS sensor
Clamp
Frame
Frame
ABS pipe
Brake switch
lead wire
FWD Battery
lead wire
*8
Pass through the lead wire between No.3 and
*5
No.4 carburetors.
Pass through the battery - lead wire inside of
*6
the brake hose.
Pass through the harness between the hose
*7
and frame.
Be careful not to pinch the wiring harness
*8
between fender and frame.
Carburetor heater
(E-02, 19)
*5
*6
*7