Troubleshooting Procedure - Suzuki 2006 GSF1200AK6 Supplementary Service Manual

22 GSF1200AK6/SAK6 ('06-MODEL)

TROUBLESHOOTING PROCEDURE

Troubleshooting should be proceed as follows. If the order is performed incorrectly or any part is omitted, a
misdiagnosis may result.
1. Gather information from the customer. (!Page 24)
2. Perform the pre-diagnosis inspection. (!Page 25)
3. Inspect the ABS indicator light. (!Page 28)
4. Output the DTCs stored in the ABS control unit. (!Page 32)
5. Perform appropriate troubleshooting procedures according to the DTCs output. (!Page 33)
If troubleshooting procedures cannot be performed, try to determine the cause of the malfunction according
to the information gathered in 1 through 4 and inspect the wiring. (!Page 19 and 20)
$
* When disconnecting couplers and turning the ignition switch to ON, disconnect the ABS con-
trol unit coupler in order to prevent a DTC from being stored.
* Each time a resistance is measured, the ignition switch should be set to OFF.
6. Inspect the ABS components. (!Page 67)
7. Delete the DTCs and check the brake operation. (!Page 34)