Suzuki 2006 GSF1200AK6 Supplementary Service Manual page 45

44 GSF1200AK6/SAK6 ('06-MODEL)
DTC TABLE
DTC
(Diagnostic
Trouble Code)
None Normal
13/C1613 Wheel speed sensor rotor malfunction (F)
14/C1614 Wheel speed sensor rotor malfunction (R)
22/C1622 ABS actuator circuit malfunction (F)
23/C1623 ABS actuator circuit malfunction (R)
25/C1625 Wheel speed sensor related mulfunction
35/C1635 ABS motor malfunction
41/C1641 Wheel speed sensor signal malfunction (F) *2
42/C1642 Wheel speed sensor circuit open (F)
43/C1643 Wheel speed sensor circuit short (F)
44/C1644 Wheel speed sensor signal malfunction (R) *2
45/C1645 Wheel speed sensor circuit open (R)
46/C1646 Wheel speed sensor circuit short (R)
47/C1647 Supply voltage (Increased)
48/C1648 Supply voltage (Decreased)
55/C1655 ABS control unit malfunction
61/C1661 ABS solenoid malfunction
*1 It goes off after running at more than 10 km/h (6.2 mile/h).
*2 The wheel speed sensor lead wire is connected to the ABS control unit, but a short-circuit or faulty conti-
nuity inside the ABS control unit caused this DTC to appear, therefore, the ABS control unit/HU assembly
must be replaced. An insufficient wheel speed sensor output voltage is the cause of a malfunction in
which the ABS is activated even if the brakes are not suddenly applied. If this occurs frequently even
though the wheel speed sensor is operating correctly, the ABS control unit/HU assembly should be
replaced.
$
When disconnecting couplers and turning the ignition switch to ON, disconnect the ABS con-
trol unit coupler in order to prevent a DTC from being stored. Each time a resistance is mea-
sured, the ignition switch should be set to OFF.
Malfunction cause
Indicator
status
ON *1
ON
ON
ON
ON
ON
ON
ON
*2 ON
*2 ON
ON
*2 ON
*2 ON
ON
ON
ON
ON
Page
—
!Page 45
!Page 47
!Page 49
!Page 50
!Page 51
!Page 53
!Page 54
!Page 55
!Page 57
!Page 58
!Page 59
!Page 61
!Page 62
!Page 64
!Page 65
!Page 66