KYMCO DINK 200 Manual page 8

1
. GENERAL INFORMATION
 After clamping, check each wire to make
sure it is secure.
 Do not squeeze wires against the weld or
its clamp.
 After clamping, check each harness to make
sure that it is not interfering with any
moving or sliding parts.
 When fixing the wire harnesses, do not
make it contact the parts which will
generate high heat.
 Route wire harnesses to avoid sharp edges
or corners. Avoid the projected ends of
bolts and screws.
 Route wire harnesses passing through the
side of bolts and screws. Avoid the
projected ends of bolts and screws.
DINK 200
No Contact !
1-6