Charging Indicator Inspection - KYMCO DINK 200 Manual

16
. BATTERY/CHARGING SYSTEM
CHARGING INDICATOR
INSPECTION
Use Sanwa electric tester for testing.
Take readings in XKΩ range.
Unit: D401
Probe (+)
Red/
Probe
Red
Black
(-)
Red/
Black
3.4~5.8
Red
mΩ
Brown/
35~65
Blue
KΩ
Red/
Blue
Green 21~41
KΩ

Charging indicator inspection

1. Turn on the ignition switch. The Charging lamp should be lighten.
2. Start the engine. The Charging lamp should be went out.
3. Inspect the output voltage of Charging indicator
~ Disconnect the battery
~ Use the voltmeter.
~ Connect the voltage
~ Connect the voltage
~ Start the engine. Open the throttle valve to keep at 8000 rpm.
~ Standard output voltage is 12~14V.
16-7
Brown Red/
Blue Green
/Blue
35~65 21~41
KΩ KΩ
3.4~5.8 3.4~5.8
mΩ mΩ
14 2
6 KΩ
14 2
6 KΩ
+ cable.
+ cable to the red wire of charging indicator.
- cable to the ground.
Red/ Black
Brown/Blue
Green
DINK 200
Red
Red/ Blue