Tickets With Black Mark - Intermec EasyCoder PM4i User Manual

Tickets with Black Mark

⇐ a ⇒ Media Width
Maximum:
Minimum:
⇐ b ⇒ Copy Length
Minimum:
Maximum:
⇐ c ⇒ LSS Detection Position
Variable, see Chapter 11.
⇐ d ⇒ Black Mark Width
The detectable width of the black mark should be at least 5.0 mm (0.2
inches) on either side of the LSS detection point.
⇐ e ⇒ Black Mark Length
Maximum:
Common:
Minimum:
⇐ f ⇒ Black Mark Y-Position
It is recommended that you place the black mark as close to the front
edge of the ticket as possible and use a negative Stop Adjust value to
control the media feed, so the tickets can be properly torn off.
Media Type Setup
• Ticket (w mark)
Note: Preprint that may interfere with the detection of the
black mark should be avoided.
Note: The black mark should be non-refl ective carbon black
on a whitish background. Do not allow any perforations to
break the edge of the media as this may cause the media to split
and jam the printer.
Intermec EasyCoder PM4i—User's Guide (IPL version)
Appendix B—Media Specifi cations
114.3 mm (4.50 inches)
25.0 mm (1.00 inches)
20.0 mm (0.8 inches)
depends on SDRAM size
21.3 mm (0.83 inches)
12.5 mm (0.5 inches)
5.0 mm (0.2 inches)
97