Intermec EasyCoder PM4i User Manual page 42

Chapter 4—Media Load
Cut-Off , cont.
1
Latch
Open the cutter and the side door.
3
Pull out the edge guide as far as it
goes and fold it down to a horizontal
position. Remove any empty core from
the media supply roll post.
28
2
Turn the printhead lift lever clockwise to
raise the printhead.
4
Fit a new roll of media on the supply
post. Fold up and adjust the edge guide
so the roll becomes fl ush with the center
section.
Intermec EasyCoder PM4i—User's Guide (IPL version)