Darkness; Label Reset Point; Form Adj Dots X; Form Adj Dots Y - Intermec EasyCoder PM4i User Manual

Chapter 6—Setting Up the Printer

Darkness

Use this parameter to make minor adjustments of the blackness in
the printout, for example to adapt the printer to variations in quality
between different batches of the same media quality. The value can be set
within the range -10% to +10% where -10 is the lightest and 10 is the
darkest. Default value is 0%.
Label Rest Point
Specifi es where labels stop for removal. Use this for peel-off (self-strip)
applications. Allowed range is -30 (furthest back) to 30 (furthest for-
ward). Default is 0. Also available as an IPL command ( ).
<SI>fn

Form Adj Dots X

Specifi es where the X-position of the origin should be placed on the
label. Allowed range is -30 (closest to the leading edge) to 30 (furthest
from the leading edge). Default is 0.

Form Adj Dots Y

Specifi es where the Y-position of the origin should be placed on the label.
Allowed range is -30 (closest to the center section) to 30 (furthest from
the center section). Default is 0.
48 Intermec EasyCoder PM4i—User's Guide (IPL version)