Bitstorm 2600 Startup Procedure; Login; Management Modes - Paradyne BitStorm 2600 IP DSLAM Installation Manual

4. Configuration

BitStorm 2600 Startup Procedure

You can initialize your BitStorm 2600 via a PC or terminal connected to the unit's
CONSOLE port. Then, using a series of CLI commands, GrandVIEW EMS or
another Element Management System, or the web interface, you can configure the
unit according to your requirements.

Login

Procedure
To log in to the BitStorm 2600:
You are now logged on and in privileged mode, which allows you to configure the
unit.

Management Modes

The startup procedure for the BitStorm 2600 system differs depending on the type
of management used:
4-4
1. Connect a PC or terminal to the CONSOLE port. (See
Chapter 2, Cabling.)
2. At the login> prompt, type admin and press Enter.
3. At the password> prompt, press Enter. The default login password is blank.
4. At the PDYN> prompt, type privilege and press Enter.
5. At the password# prompt, press Enter. The default privileged password is
blank.
Inband Management – Operates over the uplink.
Out-of-Band Management – Operates over Port 1.
April 2005
Console Port in
2600-A2-GN20-50