I Communication Setup (Communication Setup); I Serial Port Setup (Serial Port Setup) - Panasonic WJ-HD220 Operating Instructions Manual

CAM1
Notes:
• Areas adjacent to the time and date display will be
excluded from VMD when TIME&DATE EMB is set
to ON. Set it to OFF when you need to include these
areas.
• VMD should be used when the input to the unit is
from an ordinary camera. Select [OFF] to avoid use-
less VMD when a video multiplexer or combination
camera supplies the input to the unit.
• Set ALARM SUSPEND to ON when you do not want
VMD to be activated during the VMD setup.
• There may be cases where VMD does not suffi-
ciently detect changes, since it detects the
changes in luminance.
• The detection area may include areas slightly out-
side the border.
• The buzzer will beep if detection takes place during
the area setup.
4. Set the upper-left end of the detection area. Move the
asterisk to the right or left with the JogDial, and up or
down by pressing the [D] or [C] button.
REW/FF
/
STEP
/
/
5. Press the JogDial to enter the upper-left end of the
detection area. The asterisk position is highlighted.
6. Set the bottom-right end of the detection area similar to
steps 3 and 4 above.
7. Press the JogDial. The area is highlighted.
Up to 4 areas can be selected. These may partially
overlap. Repeat steps 3 to 6 to select more areas. To
deselect an area, move the cursor to the upper-left end
of the area, and press the JogDial.
38
*
PUSH PAUSE SET
•
/
q
I Communication Setup
(COMMUNICATION SETUP)
Communication parameters are set to match those of the
connected devices and the system configuration. The serial
port setup and network setup are made.
COMMUNICATION SETUP
SERIAL PORT SETUPO
NETWORK SETUPO
I Serial Port Setup
(SERIAL PORT SETUP)
The SERIAL PORT SETUP menu appears when it is select-
ed in the COMMUNICATION SETUP menu.
SERIAL PORT SETUP
PROTOCOL
BAUD RATE
DATA BIT
PARITY CHECK
STOP BIT
WAIT TIME
CTL-UNIT ADDR 1
SYS-UNIT ADDR 1
ALARM DATA
CAMERA SYSTEM SETUPO
Note: Parameters marked with * on the following pages are
default settings applicable to RS-232C.
G Protocol (PROTOCOL)
1. Move the cursor to PROTOCOL with the [D] or [C] but-
ton.
2. Select a suitable protocol with the JogDial, and press
the JogDial.
The default is PS DATA.
•
e
w
r
PS.DATA
9600
8
NONE
1
OFF
1S