Panasonic WJ-HD220 Operating Instructions Manual page 34

G Disk End Buzzer (DISK END BUZZ)
The buzzer can be set up to beep at the point where the
disk is full (remaining space 0 %). The setting is available
only when STOP is set for DISK END MODE.
1. Move the cursor to DISK END BUZZ with the [D] or [C]
button.
2. Rotate the JogDial to select the desired parameter.
The default is ON.
ON: Enables the buzzer beep at the disk end (remain-
ing space 0 %).
OFF: Disables the buzzer beep.
G Play Priority Setup (PLAY PRIORITY)
This setting places priority on a specific access point for
playing back the image data when access collisions take
place.
1. Move the cursor to PLAY PRIORITY.
2. Select an access point with the JogDial and press the
JogDial.
LOCAL: Places priority on front panel operations.
NET PLAY: Places priority on network access.
FTP GET: Places priority on access to the FTP.
NONE: The latest operation has priority over others.
G Time Adjust Setup
(TIME ADJUSTING)
IN and OUT terminals for a calibration signal are provided
on the rear panel. The master unit supplies the calibration
signal to the slave units once at the specified hour every-
day. The slave unit accepts the signal through the IN termi-
nal, and corrects its internal timer to the hour as far as the
clock deviates within 15 minutes after or before the hour.
This is convenient for synchronizing the internal clock with
other connected devices.
TIME ADJUST SETUP
TIME ADJUSTING
SET TIME→
1. Move the cursor to TIME ADJUST SETUPO in the SYS-
TEM SETUP with the [D] or [C] button, and press the
JogDial. The TIME ADJUST SETUP menu appears.
34
SLAVE
9:00
2. Select either MASTER or SLAVE with the JogDial, and
press the JogDial.
The default is SLAVE.
MASTER: The recorder supplies the calibration OUT
signal to the slave units.
SLAVE: The internal timer of the recorder is supplied
the calibration signal from the master.
3. Select the hour with the JogDial, and press the JogDial.
The hours: From 00:00 to 23:00
Note: You need not set the hour when SLAVE is select-
ed.
4. Press the [SETUP/ESC] button to go back to the SYS-
TEM SETUP menu.
G Auto Erasing Setup
(AUTO ERASING)
The redundant records on the disk can be erased every
day at 24:00 midnight. The number of days specified by
this setting stand for the number of days the records will be
protected from the present, while the records older than
that will be erased.
SYSTEM SETUP (2 OF 2)
PLAY PRIORITY
TIME ADJUST SETUP
AUTO ERASING
RESOLUTION→
HDD SAFETY MODE OFF
1. Move the cursor to AUTO ERASING with the [D] or [C]
button.
2. Select the desired number of days with the JogDial,
and press the JogDial.
OFF: Auto erasing is not applied.
1 DAY: Only today's records from 00:00 onward are
protected. Records before 24:00 yesterday are
erased.
2 to 10DAYS: Records before the specified number of
days are erased.
14, 30, 45, 60, 90, 120, 150, 180DAYS: Same as
above.
LOCAL
O
OFF
NORMAL→