I Initializing - Panasonic WJ-HD220 Operating Instructions Manual

I Initializing

You can initialize all disk contents including image data
and/or setup data.
G Initializing All Contents & Setup Data
Warning! The following are irrevocable procedures. We
strongly recommend that you copy important pic-
tures from the hard disk.
ON
1 2 3 4 5 6
1. Press the [REC STOP] button or [STOP] button to stop
recording or playback.
2. Turn off the power.
3. Set MODE switches #1 through 4 on the rear panel as
follows:
#1: ON
#2: OFF
#3: OFF
#4: ON
4. Turn on the power.
The disk contents and setup data are initialized.
NOW FORMATTING HDD
Notes:
• This will take about 40 minutes.
• When finished, be sure to carry out step 5.
5. Turn off the power, and return the MODE switches to
the previous positions. Then turn on the recorder.
24
ON
OFF
MODE
FORMAT FINISHED
PLEASE TURN OFF MODE
SW AND RESTART
G Initializing Setup Data
SYSTEM INFORMATION
HDD1 HOUR METER
HDD2 HOUR METER
HDD CAPACITY
DEFAULT→
SYSTEM VERSION
SYSTEM LOGO
1. Open the SYSTEM INFORMATION window, then move
the cursor to DEFAULT.
2. Press the JogDial to move the cursor to SET.
3. Press the JogDial.
4. Select YES with the JogDial.
YES: Initializing of setup data is enabled.
5. Press the JogDial.
SET DONE appears on the monitor after initializing.
6. Press the [SETUP/ESC] button.
The cursor moves to DEFAULT.
7. Hold down the [SETUP/ESC] button for 2 seconds to
quit the setup.
Notes:
• After closing the setup menu, the system may auto-
matically restart if any parameter on the network
has been changed.
• The menu shown above is based on the assumption
that an optional HDD is installed in the recorder. As
shipped from the factory, the hour meter is set to 1
and the capacity to half.
G Initializing Settings for Network
Setup Menu
1. Stop recording or playback if
applicable, and turn off the
power.
2. Set the MODE switches as
shown in the figure.
3. Turn on the power. Wait for a few minutes until initializ-
ing is completed.
4. Return the MODE switches to the previous positions.
Then press the [STOP] button.
Note: These procedures reset the settings exclusively
for network setup menus: USER SETUP, HOST
SETUP, FTP SETUP, MAIL SETUP, and NETWORK
VIDEO SETUP.
10000H
10000H
XXX.XXG
SET→
X.XX
ON
1 2 3 4 5 6
MODE