Displaying Nav Line, Waypoint Mark - Furuno FAR-28 Series Operator's Manual

5. VIDEO PLOTTER OPERATION
5.11.6

Displaying nav line, waypoint mark

Displaying internal nav lines
1. Left-click the MENU box to open the menu.
2. Select 8 [NAV LINE•WPT].
3. Select 2 NAV LINE DATA.
4. Select INTERNAL DATA.
5. Select 3 NAV LINE SELECT.
6. Use the scrollwheel to enter the nav line number you want to display. Select
numeral and push it to set. Note that the same nav line no. cannot be
entered more than once.
7. Use FORWARD or REVERSE to select the order to display waypoints on the
nav line. FORWARD to display them in original order or REVERSE to display
them in reverse order. Select appropriate option then push the scrollwheel.
8. To skip the next waypoint, Select 2 SKIP NEXT WPT.
9. Push the right button twice to close the menu.
Displaying external nav lines
Nav lines from an external navigator can be displayed as below. RTE and WPL
sentences are necessary to display a nav line from a navigator.
1. Left-click the MENU box to open the menu.
2. Select 8 [NAV LINE•WPT].
3. Select 2 NAV LINE DATA.
4. Select EXT DATA.
5. Do the following as appropriate:
1) Set width (0.0-9.9 nm) of the nav line with 5 NAV LINE WIDTH.
2) Turn waypoint number display on or off with 4 DSP WPT NO (page 2 of NAV
LINE•WPT menu).
3) Set turning line with 3 TURNING LINE (page 2 of NAV LINE•WPT menu).
6. Push the right button two or three times depending on which page of the NAV
LINE•WPT menu you are using.
5-30