Lifescan ONE TOUCH Profile Blood Glucose Monitoring System Owner's Booklet page 21

Step 3: Code the Meter.
While the meter
is on and after the
word insert is
displayed, press
and release the C
button; the code
number will
appear. Continue
pressing the C
button until the
number on the
display matches
the code number on the test strip vial.
The code number is now set for the
test strips you are using. The meter
will remember this code number until
M C
14
you change it. You are now ready to
do a test.
Checking the System
There are two ways to make sure
your ONE TOUCH
is working properly. The check strip
is used to check that the meter is
operating properly. ONE TOUCH
Control Solution is used to check that
the meter and the test strips are work-
ing together as a system and that you
are performing the test procedure cor-
rectly. It is very important that you do
these simple checks routinely to
make sure you get accurate results.
Profile System
® ®
®