System Setup Menu - Raymarine gS Series Installation And Operation Instructions Manual

Surveillance mode menu
Menu item /
Description Settings / Operation
Scan Width This setting determines the distance
that the camera pans left and right
when in surveillance mode. Select
from:
• Narrow — The camera will scan
approximately 20º left and right of
the center (40º total).
• Medium — The camera will scan
approximately 40º left and right of
the center (80º total). Or,
• Wide The camera will scan
approximately 80º left and right of
the center (160º total).
Scan Speed This option determines the speed at
which the camera pans left and right
when in surveillance mode. Select
between:
• Slow
• Medium
• Fast
Exit

System Setup menu

Menu item /
Description Settings / Operation
Enable / Disable This menu option should be enabled
Ball-Down when the camera is mounted upside
Installation down in the "ball-down" configuration.
Enable / Disable This menu option changes the JCU
Twist-to-Pan mode controls pan and zoom functions as
follows:
Enabled — Pan the camera by
rotating the Puck clockwise or
counterclockwise, zoom in and out by
pushing the puck in and pulling it out.
(This is default operation of the JCU).
Disabled — Pan the camera by moving
the Puck left or right, zoom in and out
by rotating the Puck clockwise and
counterclockwise.
Enable / Disable This option controls the amount of
High Power power used to hold the camera in
Standby position while it is in Standby mode.
The enabled setting will consume more
power, but will help ensure that the
camera is held in place in rough seas.
Note: If the camera moves when in
standby (due to shock or vibration),
then the Position indicator or Home
setting may need realigning (reset
the camera to realign).
Thermal camera application — Pan and tilt cameras
Menu item /
Description Settings / Operation
Enable / Disable This option controls the amount of
High Motor Torque power used to hold the camera steady
when in use. The enabled setting will
consume more power, but help ensure
that the camera is held in place in
rough seas.
The High Motor Torque mode may be
useful for power boats that operate at
higher speeds and experience high
impact environments, and can accept
higher power consumption.
Note: If the camera moves due to
shock or vibration, then the Position
indicator or Home setting may need
realigning (reset the camera to
realign).
Enable / Disable When this option is enabled the camera
Rearview Mode image is reversed and you will see a
mirror image on the display.
Enable / Disable When this option is enabled horizontal
Stabilization and vertical stabilization is turned on.
Only applies to T470SC and T473SC.
This option sets the current position as
Set Stow Position
the Stow position. The camera moves
to the stow position whenever it is
turned off or put into Standby mode.
Name Camera Use this option to name the camera.
Surveillance mode This options enables you to set
the scan width and speed when in
surveillance mode.
Exit Exit to main menu.
High power / High torque power use
Camera
State Camera setting
Standby • High Power
Mode ON
• High Torque
Mode ON
• High Power
Standby
Mode OFF
• High Torque
Mode ON
Standby • High Power
Mode ON
• High Torque
Mode OFF
Awake • High Power
Mode OFF
• High Torque
Mode OFF
Dual Single
payload payload
22 W 17.4 W
8 W 7.4 W
13 W 13 W
8 W 7.4 W
355