Radar Connection - Raymarine gS Series Installation And Operation Instructions Manual

4.9 Radar connection

The multifunction display is compatible with
Raymarine Non-HD digital radomes and HD /
SuperHD radar scanners. The scanner is connected
using over SeaTalk hs .
The radar is usually connected via a Raymarine
network switch. On smaller systems (with only
3 network devices) the radar may be connected
directly to the display.
Radar connected using Raymarine network
switch
1
1. Radar scanner.
2. Raymarine network switch.
3. gS multifunction display.
4. RayNet radar cable.
5. VCM (Voltage Converter Module) — required
for Open Arrays.
6. Power connection.
Radar cable extension
For longer cable runs a radar power and data digital cable extension is required.
Cables and connections
Radar connected directly to the display
3
1. Radar scanner
2. Multifunction display rear connector panel.
3. RayNet Radar cable.
4. Connection to power supply — Open array
scanners require a VCM (Voltage Converter
Module).
RJ45 SeaTalk
6 5
To connect a Radar using an RJ45 SeaTalk
cable additional accessories are required.
D12894-1
1. RJ45 SeaTalk
2. RayNet to RJ45 SeaTalk
3. SeaTalk
hs Radar cable connection
1
3
hs Radar cable.
hs adaptor cable.
hs crossover coupler.
1
D12895-1
hs radar
2
D12884-1
55