Superior DRT4036TEN Installation And Operation Instructions Manual page 18

Replacing Glass Door
1. Position door frame in front of firebox opening with bottom of
door tilted away from firebox (see Figure 27).
2. Hook top flange of door frame over top of firebox frame.
3. Secure 2 bottom door latches.
Reinstall the included barrier (J7450, 36" or J7456, 42")
WARNING: Reinstall any barrier removed before
operating the fireplace. The barrier is designed to
reduce the risk of burns from hot glass. Do not operate
the fireplace without the barrier installed.
NOTE: All models must have a barrier installed prior to operation.
1. Hold the barrier in front of the glass door and slide it up into the
channel underneath the upper front face (see Figure 28).
2. Slide the barrier bottom down into the slots below at the glass
door level, securing it in place (see Figure 28).
Channel
Barrier
Frame
Slot
Figure 28 - Installing Barrier
Discontinue use of the appliance immediately if doors are
damaged and contact a qualified installer for repair. Only
doors certified with the appliance shall be used.
LAVA ROCK, DECORATIVE GRATE, EMBER FLAKES AND SCRAP
LOG INSTALLATION
Lava rock, ember flakes and scrap log pieces are included with
your fireplace. Install these items while glass doors are open and/
or removed.
1. Follow instructions from Removing/Replacing Glass Door, page
17, to move glass out of the way of this installation.
2. For 36" models only: Install 3 loose logs by placing log #1, log
#2 and log #3 onto one piece log as shown in Figures 29, 29a
and 29b.
18
FIREPLACE INSTALLATION Continued
3. Place lava rock around base of burner. Make sure burner ports
are not covered (see Figure 30, page 19).
4. Place ember flakes around front and sides of burner and on burner
ports (see Figure 31, page 19). This will create the glowing ember
appearance as the flame touches the ember flakes. Do not block
burner ports or pilot ports by overlapping ember flakes in one area.
It is not necessary to use all ember material provided.
5. Place scrap log pieces randomly behind grate as shown in Figure
32 on lava rock and around (but not on) burner ports.
6. Place grate in front of logs as shown in Figure 32. Be sure grate
is balanced so it does not fall or lean onto logs. Grate does not
attach to hearth assembly.
Loose
Log #3
Loose Log #3
Superiorfireplaces.US.com
Glowing Embers
Figure 29 - Installing Loose Logs
Figure 29a - Installing Loose Log #1
Figure 29b - Installing Loose Logs #2 and #3
Loose Log #2
Loose
Log #1
Underneath
Log #2
Loose
Log #1
Loose Log #2
126721-01B