Assembly - Ariens 932037 - 724, 932036 - 524, 932504 - 524, 932505 - 724 Owner's/Operator's Manual

Ariens snow blower owner/operator manual
Hide thumbs Also See for 932037 - 724, 932036 - 524, 932504 - 524, 932505 - 724:
Table of Contents

Advertisement

WARNING: AVOID INJURY. Read and
understand the entire Safety section
before proceeding.
WARNING: Dropping or tipping over
boxed unit could result in personal
injury or damage to unit.
Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge

ASSEMBLY

Unfold Handlebar (Figure 4)
1. Loosen wing knobs and release J-bolts
from lower handlebar.
2. Unfold upper handlebar and align
handlebar holes.
3. Put J-bolts through the upper handlebar
and lower handlebar holes.
4. Tighten wing knobs to secure upper
handlebar.
1. Wing Knob
2. J-Bolt
Figure 4
ASSEMBLY
1
2
3
4
3. Lower Handlebar
4. Upper Handlebar
OS3000
Install Discharge Chute and Chute
Crank (Figure 5, 6, and 7)
NOTE: See Figure 5 for the items to install on
the unit.
1. Grease chute seat (if not already
greased).
2. Remove hardware (and chute crank
support bracket on models 932037 &
505) from top of engine (Figure 6).
3. Install discharge chute by positioning the
chute ring under retainer clip on seat
support.
4. Install chute support bracket (and chute
crank support bracket on models 932037
& 505) to engine with hardware removed
in step 2.
5. Loosen mounting nut on chute bracket
and move discharge chute up or down
until chute ring is centered between
retainer clip and chute seat. Tighten
hardware (Figure 7).
6. Slide chute crank through support
bracket.
7. Install chute crank to pinion with spring
clip.
3
2
1. Discharge Chute
2. Spring Clip
GB - 12
4
3. Chute Crank
4. Pinion
Figure 5
1
OS3500

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents