Assembly - Ariens ST11528DLE Owner's/Operator's Manual

For extended storage, clean unit thoroughly.
See Engine Manual for proper storage.
Use only attachments or accessories
designed for your unit.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping
over boxed unit could result in
personal injury or damage to unit.
Package Contents
1
4
3
OS7020
1. Sno-Thro
Unit
2. Discharge
Chute
3. Chute Rod
4. Literature
Pack with
Extra Shear
Bolts
Figure 3
Check components frequently. If worn or
damaged, replace with manufacturer's
recommended parts.

ASSEMBLY

Assembly
Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
Unfold Handlebar (Figure 4)
1. Remove the lower and loosen the upper
wing knobs on the handlebar assembly.
2. Loosen the wing nuts on the shift rod.
3. Put the speed selector lever in the first
forward position
4. Rotate the handlebars into operating
position.
5. Install and tighten all wing knobs and
wing nuts on the handlebar assembly
and shift rod.
NOTE: The handlebar has two height
positions. Adjust the handlebar height to
provide better operator comfort. See
Handlebar Height on page 26
NOTE: Model 926023 ships with the
handlebar assembly detached from the unit.
Slide the handlebar assembly into position
and fasten with wing nuts.
.
.
2
1. Wing Knobs
2. Wing Nut
3. Bolt
GB - 8
5
4
1
2, 3
OS7030
Figure 4
1
4. Shift Rod
5. Speed
Selector
Lever